BOSTONSTANGS.COM

The day I picked it up.

And then the mods....







347 Stroker N/A
10.3:1 Forged Pistons
Forged crank with forged H-beam rods
195cc Dart Pro1 heads w/Crane 1.6 Roller Rockers on 7/16" studs
Comp Cams Roller "Thumper" Cam. dur. @.050 235int/249exh .541/.526 lift
Edelbrock RPM AirGap intake with 650dp Proform carb/Holley "black" pump
Sumped fuel tank with return system. -10 braid from tank to engine compartment. -6 braid return
Full MSD Ignition
Moroso 7qrt. pan
468hp/443tq at crank
MAC 1.75" long tubes into 3" MAC Pro chamber to MAC 3" "cat" back
140amp alt.
Ron Davis aluminum radiator
Welded frame connectors
McLeod Blowshield w/Centerforce dual friction clutch
Tremec TKO 600 w/alum. drive shaft
8.8" rear w/4.10's and MAC girdle
Fully adjustable upper and lower rear control arms/Lakewood 50/50's with drag springs and air bag
Tubular K-member and frt. control arms with 90/10 Comp. Engineering struts w/coil-overs
Flaming River manual rack
Full AutoMeter gauges
Trunk mounted battery w/shut off



-- Edited by bonzcnc at 20:35, 2008-04-18